Preliminary Steps

Before you begin, do the following: • Remove rear cover and rear cosmetic shield

Procedure

1. Remove twelve Phillips screws.

Procedure

1. Remove twelve Phillips screws.

2. Disconnect the power switch and launch switch wire connectors from the inner bezel.

Replacement Note: When reattaching the cable connectors, the board will be springy. Verify secure connection.

Replacement Note: When reattaching the cable connectors, the board will be springy. Verify secure connection.

4. Lift the display assembly from the inner bezel assembly.

6. To remove the inner bezel from the bezel, start at a corner and lift up on the inner bezel while using a black stick to push in and disengage the bezel clips through the rectangular slots, shown.

7. Lift off the inner bezel.

Note: The bezel cosmetic shield with logo are also removable.

Replacement Note: Verify that the bezel and inner bezel are free of dust, fingerprints and foreign matter before reassembling.

Was this article helpful?

0 0

Post a comment