Procedure

1. With the computer on a soft cloth, remove the two screws from the I/O bezel and peel up the foil tape.

2. Tilt down the I/O bezel and remove it from the computer frame.

Note: When reassembling the computer, make sure that the I/O bezel is level and fits over all ports.

3. Install the replacement I/O bezel, and reassemble and test the computer.

Note: When installing the replacement I/O bezel, make sure the bezel shield and the mylar panel fits over the underside of the logic board, as shown below.

Was this article helpful?

0 0

Post a comment