Removing the Air Port Extreme Antennas

1. To remove the left antenna, carefully peel back the tape (circled) and the EMI backing from the rear housing as shown below. Peel back just enough EMI backing to access the antenna board. Using a flat-blade screwdriver, pry the antenna board off the rear housing.

2. Repeat step 1 to remove the right antenna (shown below).

3. Remove any other tape that secures the antenna cables to the rear housing.

4. Pull the antenna cables through the access hole in the EMI shield at the top, near the antenna board.

Was this article helpful?

0 0

Post a comment