Dxl

Adapter Do an]

On the back of the CD-ROM, Use a jeweler's screwdriver to remove the two screws on the adapter board.

Remove the adapter board from the CD-ROM

Note: Return the drive to Apple without the cables, carrier, or the adapter board. Refer to the parts database for more information.

CD-ROM, DVD-ROM,CD-RW Module Replacement

Position the drive into its carrier as shown.

1. Check that the yellow warning label is face up.

Note: if you are installing a new drive carrier, remove the blue film covering the grounding pad.

  1. Lower the CD/DVD carrier into the CD/HD carrier.
  2. Push the CD/DVD carrier forward so the carrier tabs go through the holes on the CD/HD carrier.
  3. Replace the CD/HD carrier screws.

CD/DVD ROM HD Carrier

CD/DVD ROM HD Carrier

CD/DV D ROM Drive
  1. Holding the drive carrier in the orientation shown, make sure the CD-ROM or DVD-ROM is correctly installed into the CD/HD carrier.
  2. Make sure the Slave/ Master switch on the back of the drive is still set to the Slave mode (set to the left).

Front V iew

Was this article helpful?

0 0

Post a comment