Front Outer Bezel

Before you begin, place the computer on an ESD mat and remove the bottom housing.

Outer Bezel

Tabs

1. With a jeweler's screwdriver, carefully remove the two tabs on the front outer bezel. Refer to the next graphic for a close-up of the tab removal.

2. After removing the tabs, remove the screws located under the tabs.

Note: The bezel tabs fit tightly into the rear housing. A good, hard pull upward is required to release all the tabs.

  1. Insert a plastic tool underneath the bezel.
  2. Pry the outer bezel tabs from the rear housing with a plastic tool. As you push and pry the tool inside the bezel, the side tabs will start to release.
  3. Insert the tool on the left side of the bezel and repeat.

6. As the tabs start to release, pull hard on the front outer bezel to ,QU^er release the tabs

Bezel completely.

Top Re a r ho U3 inq

Was this article helpful?

0 0

Post a comment