Headphone Board

^Warning: This product contains high voltage and a high-vacuum picture tube. To prevent serious injury, discharge the CRT.

Before you begin, remove the:

  • bottom housing
  • front outer bezel
  • top rear housing
  • divider panel assembly (with side panels, power/ analog board, and speakers attached)
1

Turn the divider panel over.

Remove the speaker to access the headphone/ audio board screw.

remove the screw using a stubby (short) screwdriver.

Disconnect the connector from the headphone board.

Remove the headphone board from the divider panel.

Power/LED Boart

Was this article helpful?

0 0

Post a comment