Preliminary Steps

Before you begin, do the following:

  • Position the computer in the service stand.
  • Remove the flat panel display.

1. Remove the three T-8 screws on the metal cable retainer. Lift the cable retainer off the panel shield.

2. Remove the four T-10 screws on the panel shield. Next, release the cables from the metal clips on the panel shield. Note: View this page at a larger size to enlarge this graphic.

3. Gently pull the cables through the hole in the panel shield.

4. Line up the notches on the panel shield hole with the video cable. Gently pull the video cable through the panel shield (See next graphic for a close-up of the video cable going through the hole). Lift the shield off the back cover being careful not to scratch the white coating on the back cover.

Note: View this page at a larger size to enlarge the graphics.

Note: View this page at a larger size to enlarge the graphics.

5. This is a close-up of the video cable going through the hole in the panel shield.

0 0

Post a comment