Replacing the Power Supply

  1. Remove the replacement power supply from its packaging.
  2. Replace the power supply. Tilt up the power supply until it clears the edge of the main circuit board. Lower it into place.
  3. Replace the power supply. Tilt up the power supply until it clears the edge of the main circuit board. Lower it into place.
Imac Power Supply

3. When the power supply is installed properly it should be flush with the gray plastic parts on the right and left sides of the power supply.

4. Connect the black power supply connector and tighten the two captive screws (circled), turning them clockwise.

5. Replace the power supply screw located on the far right.
Imac Power Supply Screw

6. Turn the middle case screw counterclockwise about five revolutions. This step prepares the back cover to be installed and secured.

Power Supply For Xserve

Hi AirPort Extreme Card

Only the AirPort Extreme Card may be installed in the iMac G5. Older AirPort Cards do not work in this computer.

Was this article helpful?

0 0
The Ultimate Computer Repair Guide

The Ultimate Computer Repair Guide

Read how to maintain and repair any desktop and laptop computer. This Ebook has articles with photos and videos that show detailed step by step pc repair and maintenance procedures. There are many links to online videos that explain how you can build, maintain, speed up, clean, and repair your computer yourself. Put the money that you were going to pay the PC Tech in your own pocket.

Get My Free Ebook


Post a comment