Fuser Heater Bulb

Before you begin, remove the fuser assembly.

Note: The fuser heater bulb is an orderable subcomponent of the fuser assembly. It provides the heat necessary to fuse toner to paper.

Left Contact Cap

J1 If

1 M if

1, ii IF

ill IF

1 1

-UU=

dJ=

L- Fuser Cover

Left Contact Cap

Cleaning Felt (Inside)

1 Open the fuser delivery assembly.

2 Loosen the screw (1) that secures the fuser cover to the fuser assembly.

3 Lift the fuser cover and the fuser cleaning felt.

4 Remove the screw (2) that secures the left contact cap to the fuser assembly. Lift off the cap.

Remove the two screws that secure the fuser board to the fuser assembly.

Note: The fuser board will hang loosely from the fuser assembly after the following step. Be careful when handling either part.

Detach the fuser board from the fuser assembly.

7 Remove the three screws that secure the left terminal mount to the fuser assembly.

8 Remove the terminal mount.

Remove the screw that secures the left heater support to the fuser assembly. Remove the support.

1 M if

M

IF

ill IF

1 1

-UU=

dJ=

Right Contact Cap

1 0 Remove the screw that secures the right contact cap to the fuser assembly. Remove the cap.

0 0

Post a comment