Installation Verification Nt Ntx Iif and IIg

Note: The following materials are required to verify installation:

  • Macintosh 512K or later
  • LocalTalk connector box for the Macintosh
  • LocalTalk connector box with a Mini DIN-8 connector (for the printer)
  • A LocalTalk cable
  • quot;Printer Installation" diskette.

1 Switch on the printer and wait about 3 minutes.

Note: If the printer delivers a startup test page, proceed to the next page. If not, refer to "Print Engine Check" in Flowcharts.

2 Switch off the printer.

3 Connect a LocalTalk connector box to the 8-pin Mini-

DIN connector on the I/O board.

4 Connect a LocalTalk connector box to the printer port at the rear of the Macintosh.

5 Connect a LocalTalk cable between the printer and Macintosh LocalTalk connector boxes.

6 Turn on the printer and wait for the test page.

7 Insert the "Printer Installation" disk in the internal hard drive and switch on the Macintosh.

8 Select the LaserWriter printer through the Chooser under the Apple menu.

9 Select Print Catalog from the File menu.

Note: If the printer produces a catalog, installation is complete. If not, refer to "Print Engine Check" in Flowcharts.

0 0

Post a comment