Ozone Filter

No preliminary steps are required before you begin Iter Case this Procedure.

Caution: Be careful when handling the ozone filter. It is brittle and can break if handled roughly.

Filter Access Door

Note: There are two filter case designs. In the newer design, you access the ozone filter through a special access door. In the earlier design you must remove the cover set and filter case from the printer before removing the ozone filter.

Ozone Filter (New)

1 Open the access door. Pull on the ozone filter tab and slide the filter out of the case.

Ozone Filter (Old)

1 Remove the two screws that secure the filter case to the fan.

2 Pull the filter case and fan duct straight up and out of the printer.

3 To remove the ozone filter, slide it down and out of the filter case.

0 0

Post a comment