Part Location

  1. Remove the two AirPort Extreme card mounting screws.
  2. Remove the two AirPort Extreme card mounting screws.
  1. Lift the AirPort Extreme card a short distance from the logic board.
  2. Disconnect the AirPort antenna wires from the card.

4. Remove the card from the enclosure.

Replacement Note: To replace the AirPort Extreme card, do the following:

• Connect the antenna wires to the card.

Important: Be sure to connect the wires that are marked 1 and 3 to the card; the antenna wire that is marked 2 should be taped out of the way.

  • Insert the card into its logic board connector at an angle, as illustrated.
  • Lower the screw end of the card down to the standoffs on the logic board and replace the two mounting screws.

Note: If you are not replacing the AirPort card, cover the connectors on the AirPort antenna wires with Kapton or other non-conductive tape to prevent them from shorting out components on the logic board.

Was this article helpful?

0 0
The Ultimate Computer Repair Guide

The Ultimate Computer Repair Guide

Read how to maintain and repair any desktop and laptop computer. This Ebook has articles with photos and videos that show detailed step by step pc repair and maintenance procedures. There are many links to online videos that explain how you can build, maintain, speed up, clean, and repair your computer yourself. Put the money that you were going to pay the PC Tech in your own pocket.

Get My Free Ebook


Post a comment