Procedure

  1. Remove any tape holding the ambient board cable to the enclosure.
  2. Disconnect the ambient board cable from the ambient board and logic board.

4. Route the ambient board cable out through the opening in the media shelf and remove the cable from the enclosure.

Important: After you replace the ambient board cable, you must reset the System Management Controller. Refer to "Resetting the Logic Board" in the Troubleshooting chapter.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment