Part Location

There are three thermal sensors, each requiring precise placement. Two sensors are attached to the bottom case near each fan and one to the heatsink.

1. For each sensor, peel back any Kapton tape, and before removing the board, mark the outline of its position with a permanent fine-point felt-tip marker.

Note: Be sure to note the orientation of the 'tail' of each thermal sensor before removal.

1. Pry up the sensor board with a razor knife.

  1. Install the replacement sensors in the exact same location. (Note: Be sure to reinstall each thermal sensor in the proper orientation, with the 'tail' facing in the correct direction.)
  2. Replace any Kapton tape.
0 0

Post a comment