Warning Do NOT allow the logic board to flex at any time Flexing the board can crack solder joints to components Give special attention at the narrow neck of the fan cutout

  1. From the left side of the board, slowly begin to lift the board, avoiding any flexing, until the thermal material on the three chips underneath releases. Do not lift the board further. Note: The thermal material should easily release. If not, verify that all screws and connectors have been removed.
  2. Remove the connector under the board, shown.

7. Remove the logic board.

Warning: Hold the board vertically along the wide sides. Do not hold the board horizontally, by the ends, or by the neck at the fan cutout, as the board's weight can cause excessive flex.

0 0

Post a comment