Modem Installation

Before you begin, do the following:

  • Disconnect the power adapter
  • Remove the rear cover
  • Remove the main battery

Caution: Review the ESD precautions in Bulletins/ Safety.

Caution: Remember to replace the battery cover after removing the main battery. Failure to reinstall the cover leaves power connected to the logic board. Removing and replacing modules with power available could damage new and old modules.

Note: The Macintosh Portable has an option for an internal 2400-baud modem. This procedure covers the installation and verification of the new modem. See "Internal Modem" in the Troubleshooting chapter for further information.

1 Push the modem cap through the rear of the computer.

2 Plug the modem card into the modem card connector.

3 Run Modem Test to verify the installation and operation of the modem. Launch AppleLink to verify operation of the modem with the telephone network.

Expansion Card

0 0

Post a comment