Reconfiguring Input Devices

Before you begin, do the following:

  • Disconnect the power adapter
  • Remove the rear cover
  • Remove the main battery
  • Remove the keyboard cover

Caution: Review the ESD precautions in Bulletins/ Safety.

Caution: Remember to replace the battery cover after removing the main battery. Failure to reinstall the cover leaves power connected to the logic board. Removing and replacing modules with power available could damage new and old modules.

Flat Cable

1 Disconnect the flat cable(s) of the input device(s) you are exchanging.

2 Simultaneously press back on each plastic tab and lift the device. Successively release all of the tabs and remove the device(s) from the computer.

3 If you are changing device positions, reverse the position of the keyboard spacer:

  • The keyboard spacer is on the right when the keyboard is on the left.
  • The keyboard spacer is on the left when the keyboard is on the right.

Keyboard Spacer —1

4 Place the front of the device in the guides at the front of the computer. Press down the rear of the device until it snaps into place

0 0

Post a comment