Antenna Board and Cables

Tools

The only tools required for this procedure is a Phillips screwdriver.

Preliminary Steps

Before you begin, open the computer, lay it on its side with the access side facing up, and remove the following:

  • All AGP and PCI cards
  • Airport Extreme Card (if installed)
  • PCI card guide
  • Speaker/fan assembly
  • Heatsink cover
  • Processor inlet frame
  • Rear exhaust fan assembly
  • PCI divider
  • Logic board

Part Location

Procedure

1. Remove the two antenna board mounting screws.

  1. Remove the Bluetooth cable (gray) and AirPort cable (black) from the clips on the underside of the logic board.
  2. Remove the antenna board and cables from the logic board.
0 0

Post a comment