PCI Divider

Tools

The only tool required for this procedure is a Phillips screwdriver.

Preliminary Steps

Before you begin, open the computer, lay it on its side with the access side facing up, and remove the following:

  • All AGP and PCI cards
  • Airport Extreme Card (if installed)
  • Heatsink cover
  • Processor inlet frame
  • PCI card guide
  • Speaker/fan assembly
  • Heatsink cover
  • Rear exhaust fan assembly

Part Location

  1. If no Airport Extreme Card or Bluetooth card was installed in the computer, disconnect their cables from the clips on the PCI divider.
  2. Disconnect the modem filter cable from the clip on the PCI divider.
  1. Remove the three black mounting screws above the PCI divider and the three black mounting screws below the PCI divider.
  2. Slide the PCI divider from under the logic board and remove it from the enclosure.
Power Mac Pci Fan

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

  • Jasmin
    How to remove fan assembly power mac g5?
    9 years ago

Post a comment