Subwoofer Speaker Assembly

Before you begin, remove the following:

  • Front bezel
  • Expansion bay cover
  • Top cover
  • Left panel
  • Left metal panel

Note: The subwoofer/ speaker assembly is in the bottom of the chassis.

Caution: Review the ESD precautions in Bulletins/ Safety.

Screv Screw

Power Supply Powermac 6500

Screv Screw

1 Lay the right side of the computer on a clean, smooth surface.

2 Using a T1 0 torx screw driver, remove the screws that secure the subwoofer/speaker assembly to the bottom of the chassis.

- Screw

2-Pin Connector

2-Pin Connector

Pull the 2-pin connector from the audio/monitor connection subassembly in the upper rear corner inside the chassis.

Powermac 6500 Subwoofer

4 Pull the subwoofer/ speaker assembly out of the computer.

Caution: Don't attempt to open the subwoofer/speaker assembly. It is one service part.

Macintosh Performa 6400

Plastic Tabs

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment