Power Book Display Cable

Before you begin, remove the following:

  • Main battery
  • I/O door
  • Top case
  • Inverter board
  • Interconnect board
  • Display bezel

Caution: The PowerBook 180 contains CMOS devices that are very susceptible to ESD damage. Review the ESD precautions in Bulletins/ Safety.

Caution: The display cable is fragile and should be handled with care.

1 Pry the display cable ferrite bead from the case.

Left Clutch

2 Pull off the center and left clutch covers.

3 Using a T-8 torx driver, remove the three mounting screws from the left clutch.

4 Remove the clutch from the display housing.

Replacement Note: Replace the short mounting screw in the top-inside clutch threading. The top-outside threading is used to mount the bezel.

_Locking

_Locking

JTsplay j Cable,

Lift the locking tab on the display connector and disconnect the display cable.

Remove the display cable from the case.

K Service Source

+1 0

Post a comment