Fan

Standoff Eject Arms

1 Unscrew the standoff located at the front of the I/O logic board.

2 Lift the expansion bay eject arms off their tracks and swing them away from the front of the I/O logic board.

Replacement Note: Make sure the expansion bay eject arms are back on their tracks before continuing to reassemble the computer

3 Hold the sides of the I/O logic board and lift up, then pull forward.

Caution: Do not use the long, narrow part of the I/O logic board as a handle. The board could break at this point. Hold the board by the outer edges.

Replacement Note: After repositioning the I/O logic board, check that the IR diode leads are not bent and the IR diodes are aligned properly and facing out the IR window.

Note: If you are replacing the I/O logic board, remove the PC Card cardcage from the original I/O logic board and install it on the new I/O logic board. Refer to "PC Card Cardcage" procedures in this chapter.

0 0

Post a comment