Procedure

Note: Lift up any Kapton tape as necessary and reserve for replacement.

1. Remove the two screws and remove the small board (if a left ambient light sensor board was not removed in the preliminary steps).

2. Carefully lift wires out of routing channels on the left speaker.

  1. Remove the screw and nut, then carefully lift out the speaker assembly.
  2. Disconnect the speaker cable from the Sound/DC-in board.

5. Install the replacement speakers, and reassemble the computer.

Replacement Note: Needlenose pliers may be helpful when reinstalling the nut.

6. Testing the computer should include using the Sound system-preference pane to test the left and right speakers.

Was this article helpful?

0 0

Post a comment