Service Source

Removing The Base Apple Studio Crt

Studio Display 17 CRT, 16 VIS, 2002 Apple Computer, Inc. All rights reserved. Warning This product contains high voltage and a high-vacuum picture tube. To prevent serious injury, review CRT safety from the displays product area of rollover links on Service Source online. Warning Never use a grounding wriststrap until after discharging the CRT and setting up an ongoing ground connection. Warning When the rear housing is removed, avoid the sharp sheet-metal edges of the EMI shield, board...

Apple Monitor 17 Crt Adc Per Macbook

Before you begin, remove the following Deflection board and mount assembly 1. Remove four screws 1 from the metal degauss frame. Remove four more black screws 2 from bezel mount and degauss frame. 2. Lift slightly the bottom side of the degauss frame and disconnect the power button cable and the launch button cable. Remove the CRT from the front bezel assembly.

Remove CRT Shroud

Crt Discharge Tool

Before you begin, remove the following 1. Remove two screws from the CRT shroud. Discharge the CRT and Remove Anode Cap CRT discharge tool 076-0392 Before you begin, remove the following 1. Attach the grounding clip of the CRT discharge tool to the metal frame of the CRT. 2. Insert the tip of the CRT discharge tool beneath the anode cap and make contact with the edge of the anode anode aperture . 3. Fold up the anode cap, then squeeze together the metal clip to remove it from the internal edge...

Info

Flat Crt Bezel

Before you begin, remove the following Deflection board and mount assembly 1. Use a small, plastic flat-blade screwdriver to disengage four plastic mounting tabs, and pull up to separate the bezel mount from the front bezel. Remove two screws and the launch button board 2 from the bezel.