Paper Sensor

Before you begin, remove the following Note The paper sensor is located on the rear of the printer frame assembly. The paper sensor cable attaches to the front of the logic board. 1 Note The paper sensor cable is attached to the back of the printer frame with double-stick tape. Carefully peel off the paper sensor cable, leaving the tape in place on the metal frame. 2 Carefully release the tab at the bottom of the paper sensor. Insert a jeweler's screwdriver between the paper sensor and the...

Cartridge Hook

Before you begin, remove the following Caution Place the printer frame assembly on a padded surface, taking care not to crumple the ribbon cables under the frame. Note The cartridge hook kit contains the cartridge hook, lever, spring, and holder. Using a jeweler's screwdriver, gently pry between the top of the cartridge hook holder and the adjacent plastic of the cartridge carrier. Push the cartridge hook holder slightly away from the cartridge carrier. 3 Using small needlenose tweezers, gently...

Fuse

Before you begin, remove the following Review the ESD precautions in Bulletins Safety. Using a small flat-blade screwdriver, gently pry up and release the two tabs on the bottom of the printer. 2 Lift the rear of the logic board cover and release it at the forward tabs. Using a jeweler's screwdriver, gently pry the ends of the fuse out of the holder.

Printer Frame Assembly

Printer Frame Assy

Before you begin, remove the following Note The printer frame assembly comes with the platen cover, paper sensor, cartridge hook, and forms thickness lever installed. Do not remove these parts prior to returning a printer frame to Apple. Caution You must replace Revision A and Revision B printer frame assemblies like-for-like. If you are replacing the frame assembly, see Revision Identification in Additional Procedures. 2 Slide the RFI shield out the front of the printer. 3 Pull the printer...

Revision Identification

Note This procedure explains how to distinguish between Revision A and Revision B of the StyleWriter. You must replace Revision A and Revision B logic boards and printer frames like-for-like. worm screw until the V-groove of the large gray gear faces up. Note It may be necessary to push gently on the carriage hook assembly or to rotate the worm screw slightly to slide the carriage hook assembly. Slide the carriage hook assembly to the left by guiding the lock flap through the V-groove of the...