Part Location

Xserve Battery Location

1. Lift the Xserve RAID Card battery straight up off its three mounting posts.

Note: Adhesive on the underside of the battery holds it in place on the enclosure floor.

2. Remove the battery from the enclosure.

Replacement Note: Before installing a new battery, remove the protective film covering the adhesive on the underside of the battery. Then lower the battery into place on its three mounting posts.

Important: Do not drop, disassemble, crush, incinerate, or expose the battery to temperatures above 212° F (100° C). Stop using the battery if it appears damaged in any way. Replace the battery only with an Apple-authorized battery for this product. Dispose of used batteries promptly according to your local environmental guidelines.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment