Procedure

1. Loosen the two captive screws that secure the riser bracket to the back panel.

2. Carefully pull up on the bracket and riser, to disconnect the riser from the logic board. If you are removing a blank riser card so that you can install a graphics card in the riser, do the following:

• Remove the screw on the riser bracket and remove the port access cover.

Seat the PCI card in the riser slot and replace the screw to secure the card in the riser.

~ Screw

-PCI riser

3. If you are removing a riser card so that you can replace it with a new riser card, remove any expansion card installed in the original riser card and transfer the card to the replacement riser.

0 0

Post a comment